Tecom S.r.l - General Catalogue 2025 - Self-aligning bearing supports

265 6 9 10 7 8 11 Self-aligning bearing supports Mounting specifications Closed cover Open cover Screwdriver seat Assembly of the protection cover: 6. On the back of the cover, grease the seat of the sealing gasket (OR) along its entire circumfer- ence. In open type covers, the space between the two lips of the sealing ring must also be greased. 7. Insert the gasket into its seat. 8. On the body of the support, grease the edge of the cover attachment along its entire circum- ference. 9. Position the lower edge of the cover on the body of the support, keeping the screwdriver seat facing downwards. By mounting the cover with the screwdriver seat facing downwards prevents the infiltration of liquids and facilitates their expulsion in the event of stagnation. 10. Apply a little pressure (by hand or with a small hammer) near the upper edge of the cover until it clicks into its seat. Removal of the protection cover: 11. Insert the tip of a flat screwdriver into the appropriate seat on the cover; then lever it outwards.